What is ABS Recycled Material


Release time:

2021-04-12

ABS recycled material is a kind of general thermoplastic engineering developed in this century. Plastics have very good rigidity strength and processing fluidity, and good toughness, which brings more convenient use requirements for industrial production and life as well as various engineering fields. ABS recycled materials and other materials have good structural combination performance, so it is easier to print layers and coatings on its surface.

ABS recycled materialIt is a kind of general thermoplastic engineering developed in this century. Plastics have very good rigidity strength and processing mobility, and good toughness, which brings more convenient use requirements for industrial production and life and various engineering fields. ABS recycled materials and other materials have good structural combination performance, so it is easier to print layers and coatings on its surface.


PP塑料颗粒


The toughness is very good, the impact resistance and wear resistance are good, and the size is relatively stable, but the bending strength and compression strength are relatively poor mechanical properties of plastics, and are also greatly affected by temperature. At minus 40 ℃, it can still show some toughness, and the thermal deformation temperature can be increased to 10 ℃ after annealing. ABS recycled material electrical insulation is very good, and almost will not be subjected to temperature and humidity in most of the environment to use.
PP granule manufacturersTo tell you, ABS recycled material is not affected by water, inorganic salt, alkali and other acids, but it can be dissolved in similar acids, vegetable oil and so on. These erosion will cause stress cracking. However, the weather resistance is relatively poor, and it is prone to degradation under the action of ultraviolet rays. If it is placed outdoors for half a year, the impact strength will be reduced by half. Easy to burn the flame, yellow, and there is black smoke burning, but not low, but also issued a special cinnamon flavor, flame retardant products.
The melt viscosity is very high, and its fluidity performance is better than PVC, but it is worse than PE, PS and PA. ABS recycled material has very good molding processing characteristics, its products surface finish is very high, and has good coating and dyeing properties, can be plated into a variety of colors, its specific heat capacity is very low, in the mold stick block is relatively fast, the mold cycle is short, the size is stable, the surface is very glossy.
And the thermal stability is good, not easy to appear the phenomenon of thermal degradation, high water absorption performance, should be dried before processing, the special requirements of the product also need 70 ℃ to 80 ℃ 10~18 hours of processing. Abs products are prone to internal stress during processing. If the stress is too great or the products are prohibited from stress cracking, annealing treatment should be carried out. The specific method is to put the products in a hot air circulation drying oven at 70 ℃ to 80 ℃ for 2-4 hours, and then cool them to a greenhouse. ABS recycled materials can be injection molding, extrusion, calendering, blow molding and so on these methods to make molding.PP plastic granulesAlso need attention.
Hello! Welcome to the official website of Dongguan Huasuan Plastic Material Co., Ltd.
Address: No. 78, Qiaolei Beimen Industrial Zone, changping town, Dongguan City
Tel: 86 0769 82020719
Mobile Phone: 13802397965
Fax: 86 0769 82308699








Copyright©2023 Dongguan huazuan plastic material Co., Ltd. All Rights Reserved

绿美佳塑胶